2023 AIChE Annual Meeting

(189e) Renewable Small-Scale Synthesis of Ammonia and Its Improved Separation with Reactive Absorption

Authors

Chinomso Onuoha - Presenter, University of Minnesota, Twin Cities
Alon McCormick, University of Minnesota-Twin Cities
Paul J. Dauenhauer, University of Minnesota
Edward L Cussler, University of Minnesota
Michael Reese, University of Minnesota West Central Research and Outreach Center
Mahdi Malmali, Texas Tech University
Tejas Nivarty, University of Minnesota
Bill Straub, University of Minnesota
Prodromos Daoutidis, University of Minnesota-Twin Cities
Matthew Palys, University of Minnesota
Zac Pursell, University of Minnesota
Deepak Ojha, Indian Institute of Technology Madras, Chennai, India
Sameer Parvathikar, University of Michigan
Ammonia absorber columns offer an alternative separation unit to replace condensation in the Haber-Bosch synthesis loop. Metal halide salts can selectively separate ammonia from the reactor outlet gas mixture and incorporate it into their crystal lattice with remarkably high thermodynamic capacity. While the salts’ working capacity can be limited and unstable when they are in their pure form, the capacity can be stabilized and increased by including a porous silica support.

Here, we discuss optimal conditions for uptake and release of ammonia. The production capacity (ammonia processed per unit absorbent and per unit production time) depends on processing parameters - including uptake and regeneration temperatures, ammonia partial pressures, release time, and sweep gas flow rate. Moreover, attention should be paid to balancing the release time with the full cycle time and bed size to ensure that the uptake breakthrough time makes efficient use of the bed. These parameters are mutually interdependent, so their optimization can be nontrivial, but rewarding. In addition, absorbent synthesis methods and thermal conductivity impact the ammonia capacity of the absorbent material as well as how quickly it can be cycled.

To address this challenge and to allow a large set of experiments, an automated dynamic absorption system was designed and fabricated. This system was used to rapidly screen uptake and release conditions, to assess material stability, and to identify optimal cycling conditions. The large amount of experimental data obtained from this automated system, and the associated mathematical models validated by this data, were found to be an essential tool to optimize the design of the absorber column. In turn, this task is essential to assess improvement in the techno-economic prospects for this new separation approach.

We also share some of our findings regarding the scaleup. These indicate potential processing challenges that need attention in design (de-risking) to ensure optimal operation in bench-scale and production-scale units.